Fc1178bc Mptools ((link)) Here

Frequently used to reveal the actual capacity of "fake" drives (e.g., a drive advertised as 2TB that is physically only 32GB) Configuration:

Allows modification of Vendor ID (VID), Product ID (PID), and manufacturer strings Where to Find Resources

Low-level formatting, firmware flashing, bad-block remapping. fc1178bc mptools

Once completed, the software slot status will turn green and display a prompt. Safely eject the USB drive, unplug it, and reinsert it into the PC to format it through the standard Windows Explorer file system. Troubleshooting Common Flashing Failures Root Cause Drive not detected by tool Controller is stuck in a loop or hardware disconnected.

Unlike standard formatting tools built into operating systems, MpTools operates at a low level by communicating directly with the flash controller. Frequently used to reveal the actual capacity of

FirstChip FC1178BC MpTools V1.0.2.10 2018-04 ... - USBDev.ru

| Error Message / Issue | Likely Cause | Troubleshooting Steps | | :--- | :--- | :--- | | | The controller is stuck in a "ROM mode" with a VID/PID of FFFF:1201. | This indicates the drive is in a recovery state, which is often a good sign. It means the MPTool should still be able to reprogram the firmware. Try different MPTool versions and ports. | | Scan Fail(3) or Fail(8) | Incorrect tool version, wrong settings, or a severely degraded NAND chip. | This is a common error. Try a different version of the MPTool. Also, double-check your "Scan Level" and that the Flash ID matches your NAND chip. | | Capacity shows as half the original after repair | The original capacity was artificially "expanded" in the factory. The tool has successfully restored it to its real, physical size. | This is not an error , but a successful outcome for a "fake" or "expanded" USB drive. The capacity is now correct. | | Tool reports success, but drive still has no capacity in Windows | The drive likely needs a simple volume creation and format. | Go to Disk Management ( diskmgmt.msc ), initialize the disk, create a new simple volume, and format it. | - USBDev

It reloads the firmware, which can fix drives showing as "Please Insert Disk," zero-capacity errors, or USB drives that cannot be recognized by Windows.

When these drives fail, standard Windows formatting utilities are completely useless. Repairing them requires specialized mass-production firmware flashing software: (also known in engineering circles as i-T117x MpTools ).